How do I reset my Honda CD player?

How do I reset my Honda CD player?

How to Reset My Honda Radio After Putting in a New Battery

1. Turn the ignition key to the “On” position, but don’t start the engine.
2. Turn the radio on by pressing in on the volume control knob. After 10 seconds, turn the radio off. Press and hold the power button for two to five seconds and watch the radio display.

How do I fix Mecha error?

Follow the steps below to troubleshoot if the unit not responding properly or displays MECHA ERROR or MECHANICAL ERROR.

1. Remove any CDs or tapes from the unit.
2. Turn off the unit.
3. Unplug the AC power cord for 15 seconds.
4. Ensure the recommended speakers are attached properly and that the wires are not shorted.

Why does my car CD player say error?

Sometimes a CD player will display a “No Disc” error. What this means is that the CD player, for some reason, does not recognize the disc. There are various reasons for this error, from the CD lens eye being dirty to a CD format that is incompatible with the player. Troubleshoot through process of elimination.

What is focus error on CD player?

It means the eye that reads the data lines in the disk is out of wack. It needs to be cleaned and calibrated by a professional, and then it should work again.

What does CD Mech error mean?

Mech Error – This indicates a mechanical error, often due to scratched, dirty or damaged discs. Changer Error – Eject the disc, inspect it, and reload it if it is undamaged and clean. Check Disc Load – Eject and reload the disc.

What does Error 3 mean on CD player?

“Error 3 means that there’s a mechanical problem with the cd loading system. Now what you have tried is the only method to repair however I would suggest you disconnect the battery’s negative battery terminal overnight and connect it back in the morning, see if this causes the cd changer to eject all discs.

https://www.youtube.com/watch?v=N1Aw0AkwbCM