How to setup Alice Gate VoIP 2 Plus WiFi?

There are 2 different version of Alice Gate VoIP 2 Plus Wi-Fi. if you have an AGPF you set with the wto pin for the serial. Hi, what is your ISP. There are 2 different version of Alice Gate VoIP 2 Plus Wi-Fi. if you have an AGPF you set with the wto pin for the serial.

How to use Alice gate with serial console?

I can suggest you to use Alice gate with the following network configuration using serial console: For more info read switch config. You have to use the “vi” editor to edit the file ect/config/network . To save what you write you must press Esc, then write :w and then press enter to save (CTRL + Z to exit without save).

What are the settings for Pirelli Alice Gate VoIP 2 Plus?

Some revisions might have the connector tilted by 90 degrees and placed more or less at the center of the board. Settings are 115200 8N1. NB: a short circuit between pins RX and TX at power up puts the device in a recovery mode with IP 192.168.1.1 from where a new firmware can be uploaded.

Is the Pirelli Alice gate compatible with OpenWrt?

There are several models of Alice Gate out there, that are not supported at the moment. Please add the installation procedure here. Some revisions might have the connector tilted by 90 degrees and placed more or less at the center of the board. Settings are 115200 8N1.

How to restore Pirelli Alice Gate VoIP 2 Plus?

From this file you can extract all you need to do a full restore of your device, both via jtag or via CFE. Now unmount your flash key, put the file in a safe place and reboot the Alice stopping the boot process at the bootloader prompt pressing some keys.

Why is my Pirelli Alice gate not accepting OpenWrt?

NB: a short circuit between pins RX and TX at power up puts the device in a recovery mode with IP 192.168.1.1 from where a new firmware can be uploaded. OpenWrt binaries are refused, though, because of invalid CRC.