Where is the transmission control module located?
The transmission control module can often be found below the cover at the back of the transmission and should be located just near the engine control module’s position. The position of the transmission control module is found under the center console in the interior or under the hood near the car battery.
What causes a transmission control module to go bad?
Damage to the control module can be caused by voltage overload, when there is a short in the solenoid or actuator circuit; when water causes the circuits to get shorted out; or vibration and thermal stress.
Is it expensive to replace a transmission control module?
But on average, car owners pay somewhere between $850 and $925 for transmission control module repairs. The parts associated with working on a transmission control module usually run people about $750 to $800, while the labor comes in at about $100 to $125. This makes it a pretty costly repair job.
Where is the Transmission Control Unit located on a Mercedes C230?
THE TRANSMISSION CONTROL UNIT IS LOCATED BEHIND THE PANEL ON THE PASSENGER’S FEET AREA. Car would get stuck in park from time to time. Limp home mode activated a few time. Faulty gear selector lever module and transmission plug. Both replaced. I had this problem on my 2004 C320 2dr sport coupe.
Why is my Mercedes C230 hard shifting without automatic transmission?
The electrical connector at the automatic transmission may leak fluid. Over time leaking fluid could migrate through the wiring harness and damage the transmission control module. If that happens a new harness and control module may be necessary to correct the problem. Ready to sell? CarMax buys all kinds of cars
How much does a Mercedes C230 transmission cost?
Over time leaking fluid could migrate through the wiring harness and damage the transmission control module. If that happens a new harness and control module may be necessary to correct the problem. The average cost for a Mercedes-Benz C230 General Diagnosis is between $143 -$180.
How do you remove transmission wire from Mercedes C230?
YOU WILL NEED A 7MM SOCKET WRENCH TO REMOVE THIS PART. THE CONNECTOR US ON THE FRONT PASSENGER SIDE OF THE TRANSMISSION. THE WIRES ARE REMOVED BY PULLING A SMALL LEVER- WHITE-YELLOW PASTIC LEVER DOWN FROM LIKE 11:00 TO ABOUT 6:30 (COUNTERCLOCKWISE PULL) YOU NNED A SMALL 7MM SOCKET TO REMOVE THE FAILED FITTING.
