How do I print a Lexmark configuration page?
From the printer control panel, press System. Press or repeatedly until Information Pages appears, and then press OK. Press or repeatedly until Configuration appears, and then press OK. After the configuration pages print, Select Function will appear on the display.
How do I reset my Lexmark MS310DN IP address?
Lexmark MS310DN E260DN reset dhcp settings
- open front of printer as if you were changing toner.
- hold down the go/ ok/ green button while turning on the printer two lights should flash on the right (if you want you can press ok to print off instructions but the are below)
How do I change the default settings on my Lexmark printer?
Under the Administration menu, click on Set Default Options. Go to the options that need to be set as default. For example, select Color > Black & White > select ON (or select your preferred setting; i.e., Printer Setting, Off, On), and then click on Set Default Options.
Where is the menu button on Lexmark printer?
Press the Menu ( ) button on the printer operator panel. Press the down arrow button ( ) until the check mark on the left is in front of Reports. Press the select ( ) button once….Solution.
|2||Make sure there is paper loaded in the paper tray.|
|3||Press the Menu ( ) button on the printer operator panel.|
How do I print a test page on a Lexmark printer?
- Make sure the printer is at Ready or in Power Saver mode.
- Press the left (<) or right (>) arrow Menu button until you see UTILITIES MENU as a choice.
- Press the Select button.
- Press the left or right Menu button to cycle through these choices until Print Menus appears.
- Press the Select button.
How do I reset my Lexmark ms310dn to factory settings?
From the home screen, touch Settings > Device > Restore Factory Defaults > Restore Settings > Restore all settings > RESTORE > Start.
What is my Lexmark printer IP address?
View to the Devices & Printer settings. In the properties box, go to ‘Ports’, You can see the network port of the printer is ticked here, choose the port and tap on Configure Port. In the Configure standard box you can see the actual IP address of your Lexmark Printer.
How do I choose which tray to print from?
In the application from which you want to print, select File > Print. Select PublicPrint, then click Properties. In the Properties window, click the Detailed Settings tab. In the Input Tray dropdown menu, select the tray from which you want to print.
What is NPA mode?
Purpose: To specify whether the printer performs the special processing required for bidirectional communication, following the conventions defined in the Network Printing Alliance (NPA) Protocol.
What’s the print speed on a Lexmark ms310 DN?
The Lexmark MS310dn network-ready laser printer with internal 2-sided printing, a 800 MHz dual-core processor, 128MB of standard memory, 300-sheet standard input and a print speed of up to 35 ppm quickly and easily performs tasks. Enjoy print speeds up to 35 pages per minute plus print your first page in as little as 6.5 seconds.
How to print the menu settings, network settings?
The printer should display Printing Network Setup Page and the network settings page will print out. NOTE: The printer will return to the Ready state after the menu settings page prints. Check the first section on the network setup page to confirm that the Card Status is “Connected”.
Why is my Lexmark printer not printing correctly?
If one of the internal pages prints correctly, the source of the printing problem is probably not the printer hardware. This is especially helpful in diagnosing communications problems (for example, if the printer does not respond at all when you send a print job to it).
Where to find serial number on Lexmark printer?
When calling Lexmark Technical Support for service, please be prepared to describe the problem you are experiencing or the error message on the display. You will also need to provide your printer’s model type and serial number. This information can be found on a label on the inside of the front cover.