How do I reset my BIOS back to default?

How do I reset my BIOS back to default?

Reset the BIOS to Default Settings (BIOS)

1. Access the BIOS Setup utility. See Accessing BIOS.
2. Press the F9 key to automatically load the factory default settings.
3. Confirm the changes by highlighting OK, then press Enter.
4. To save the changes and exit the BIOS Setup utility, press the F10 key.

Why does my BIOS keep resetting?

If bios always resets after a cold boot there is two reasons one the bios clock battery is dead. two on some mother boards have a bios clock jumper that is set to reset bios. those are what cause bios to reset on purpose. after that it could be a loose ram chip or a loose pci device.

What happens if your BIOS resets?

Resetting your BIOS restores it to the last saved configuration, so the procedure can also be used to revert your system after making other changes. Whatever situation you may be dealing with, remember that resetting your BIOS is a simple procedure for new and experienced users alike.

Does resetting your PC reset the BIOS?

Resetting windows will not affect the BIOS. I did this all the time when reinstalling Windows, and the BIOS is completely unaffected. Just make sure your boot order is set to the drive with windows installed. Be sure to backup your data before resetting though!

Is the Intel desktop board dp965lt BIOS identifier?

This product specification applies to only the standard Intel®Desktop Board DP965LT with BIOS identifier MQ96510A.86A. Changes to this specification will be published in the Intel Desktop Board DP965LT Specification Update before being incorporated into a revision of this document.

Why does my BIOS reset when I lose power?

I am back with another weird issue. Whenever my computer loses power, the BIOS settings reset. I replaced the battery on the motherboard twice (both right out of the package batteries) but the issue persists. If my computer stays plugged in, it is fine.

How to restore BIOS setting after power cable is removed?

Re-connect the power and boot the device, press Delete to enter BIOS for setting b. Three pins are on CLRTC . At the status of shutdown with power cable removed, please change CLRTC jumper from default value [1-2] to [2-3] for aorund 5-10 seconds.

What should I do if I Forgot my BIOS setting?

Abnormal BIOS setting or overclocking sometimes leads to boot failure on devices. If you forget the original BIOS setting, try to restore BIOS by below methods: 1.Use the CLRTC header on motherboard to clear BIOS setting. Three methods are suggested below according to different motherboards: