How do I clean my Maxtrax walking boot?

How do I clean my Maxtrax walking boot?

CLEANING INSTRUCTIONS: To clean liner, hand wash in cold water using mild soap. Air dry. Note: If not rinsed thoroughly, residual soap may cause irritation and deteriorate material.

How do you put a walking boot back together?

How do I put on the walking boot?

1. Sit down and place your heel all the way to the back of the boot.
2. Wrap the soft liner around your foot and leg.
3. Place the front piece over the liner.
4. Start to fasten the straps closest to your toes then move up your leg.
5. Tighten the straps so they are snug but not too tight.

What does the MaxTrax Air Walker walking boot do?

MaxTrax Air Walker The MaxTrax Air Walker is a completely adjustable walking boot. This boot supports healing ankles that are recovering from injury or surgery. The Air Walker increases stability while decreasing pain and edema. This boot provides a cost-effective option for serial casting and… more info

How do you put Velcro on walker boot?

Release the Velcro straps from your hand. Thread the first Velcro strap (the strap closest to your toes) through the middle of the plastic threading bar on the other side of the boot. Then pull the strap over the bar and back to the other side.

How to put on a medical walking boot for…?

It is 11 inches tall and is constructed out of a strong polymer plastic, providing the fracture boot with protection and support. For maximum comfort, the boot for fractured toe and other injuries is lined with a deluxe foam material that is soft and comfortable against your skin. It has two straps over the foot and one over the ankle.

How to open the front of a walking boot?

Open the boot by detaching the Velcro straps. Most boots will have between two and five Velcro straps depending on your injury and the stability of your ankle. Hold the Velcro straps back with one hand so that the front of the boot is completely opened. 3 Sit down and place the boot behind your leg. 4