How do you remove a Cannondale SI spindle?

Thread the smaller inner piece into the bottom bracket spindle threads using an 8mm hex wrench. Thread the outer piece into the crankarm threads until it is tight. Use the 8mm wrench to back out the inner piece in the spindle. This will pull the arm off the spindle.

What is the difference between BB30 and BB30A?

The BB30A is similar to the BB30 standard, but the frame BB shell is 5mm wider on the non-drive side. BB30A system uses thin spacers and/or a wave washer between the bearings and the crank arms to take up any slack and micro-adjust the chainline of the crank.

How to install a sisl2 Hollowgram road crankset?

Installation 1. Install the BB30 or PRESSFIT 30 BB bearing system into the BB shell normally. 2. Connect the SISL2 drive side crankarm to the spiderring. Apply Loctite 242 to the crankarm spidering interface and lockring. Tighten the lockring to 47Nm (34 FtLbs) using the Cannondale special tool KT012/. See page 2.

Where do you put grease on sisl2 crankset?

Apply grease to the drive side end of the 109mm SISL2 spindle and the crankarm spline hole. Also apply grease to the fixing bolt threads and thin washer.

What’s the best way to remove a Cannondale crank arm?

Rating is available when the video has been rented. This feature is not available right now. Please try again later. Don’t pay for $50 nuts just to take off Cannondale SI/SISL/SISL2 crank arms. Just get a Park Tools CCP-22 crank arm remover ($12) and a 5/8 aluminum rod ($2). This video shows you exactly how that works. Loading…

How do you remove a Hollowgram SL crankset?

Crankarm Removal 1. Insert an Allen key fully into the fixing bolt. Hollowgram Hollowgram SL 8mm 10mm 2. Hold crankarm with your hand and turn the Allen key counter-clockwise to remove bolt from the crankarm . 3. Remove the thin steel washer under the bolt head.