Do they still make warm morning stoves?
Warm Morning was a trade name for some of the heaters made and sold by the now defunct Locke Stove Company. To my knowledge, this company went out of business decades ago, although some models and parts were still made by Martin Industries, another stove manufacturer. However, they too went bankrupt (2002, approx.)
What is a warm morning stove?
“Warm Morning wood stoves are pretty large heaters that were popular from the 1940s through the end of the century. They had models for oil, wood, and gas as well as coal. Some were a coal/wood dual heat solution.
Why is my coal stove not getting hot?
The main cause of not enough heat is either the design of the furnace/boiler, or lack of a barometric damper, or draft control.. Do you have a barometric damper installed in the chimney flue?? How tall is your chimney? And, this is important,, every house is different.
How do you light a warm morning stove?
To light the pilot you hold down on valve for a minute while holding a flame from a long lighter at the pilot orifice. You hold down on the valve for this minute while it is lit and then let go. The flame should stay lit. If the flame should go out then you have a bad thermocouple.
What kind of coal is in warm morning 414?
Location: Elkhart county, IN. Coal Size/Type: Nut Anth. be very careful with your bricks. if you have a single good example of each the the shapes and sizes NOW is the time to make molds so you can recast others. IF you find any new old stock bricks expect to pay $80+ each for them.
Why are the bricks on my 414 stove so bad?
Thanks kingcoal and mcgeiver…looking at the pics posted of the new bricks it’s very apparent that the lower bricks in my new to me 414a have been beat to death somehow. Maybe they chunked wood really hard into the stove repeatedly. The rest of the stove is in relatively good shape. After the holidays I will tear it down and start the rebuild.
Where can I find a 617 coal stove?
The flue connection plate on top of the 617 is able to be flipped around to allow the flue to exit the rear of the stove instead of the top. 4 or 6 screws to loosen, flip it and bolt it back down. I would prob use a sealer of some kind to reseal the plate. Location: Elkhart county, IN.
How big is a hand fired wood stove?
Good afternoon Shannon, I sourced the firebrick from one of our local ready mix concrete suppliers. Basically the same brick one would line a stove with or build a fireplace and sold at hardware stores. It was a mix of full size (9″x4.5″x2.5″) and split brick (9″x4.5″x1.25″) trimmed with 4.5″ angle grinder with a diamond masonry blade.
