How much does it cost to run electrical for a pool?
Electricians charge $500.00 – $1500.00 to wire up an above-ground pool. Included in the cost should be all supplies. You will need an 18-inch deep trench to run the service from the breaker-box to the pool area.
Do you need an electrician to install a pool?
Even if you think you have the knowledge to properly install the electrical work needed for a pool, you will still need a licensed electrician to complete the job in order to pass inspection by your state. When looking for an electrician, make sure they have experience with swimming pools.
How much does it cost to rewire a pool pump?
Cost of Pool Pump Installation Replacing an existing pump with the same model and style has a cost closer to $200. Most people pay around $300 for labor on a pool pump installation out of the $1,000 total.
Can an electrician install a pool pump?
Pool installation If your planned pool includes a water heater, sand filter, pump or even mood lights, you should be speaking with an electrician. Many of these extras may require new wiring and circuits to be installed, making it a job for a professional, in other words.
Do Electric pools need GFCI?
Electrical Equipment GFCI protection is required for ALL receptacles that supply power to the pool equipment, such as water heaters and pump motors.
How do you run an electric pool pump?
Plug in the pool pump and cover it with a weatherproof cover. With the main service off to the house, wire in GFCI circuit breakers to the electrical panel. Connect an 8-gauge wire to the metal posts of the pool, the pump, and the metal plate on the skimmer and then wire that to the pump to bond the entire pool.
Does pool pump need GFCI?
-NEC requires GFCI protection for all pool pumps. A pool builder or electrician cannot install power to your pool pump per code without one. -Moisture from rain, sprinklers, or runoff causes GFCI breakers to trip as well.
What kind of electrical is needed for a pool?
If you need to know the electrical requirements for your inground pool, here is a list of common pool equipment and the approximate volts and amps required for each: Pool Pump: 240v, 10amps. Salt Water Chlorinator: 240v, approx 5-8 amps. Pool Heat Pump: 240v, 50 amps.
How long do pool motors last?
Your pool’s pump is the wet end of the operation, it houses the pump basket. Pumps should last through the initially installed motor and perhaps as many as two or three replacement motors, usually 10-12 years. Modern pumps are made of hard plastic and will over time warp.
What does a pool electrician do?
You may have an idea of what the problem could be, but it’s always a good idea to call a professional pool electrician. An electrician will be able to diagnose and fix any of your pool’s problems safely while ensuring that all other safety measures are in place and working as well.
How far does an outlet have to be from a pool?
Receptacles for pumps and motors must be located between 6 and 10 feet from the pool walls, and they must be GFCI-protected and locked. Outlet receptacles for general use can be no closer than 20 feet from a pool or in-ground spa if they are not GFCI-protected, and no closer than 6 feet away if they are GFCI protected.
