How do you drain a carburetor bowl?

How do you drain a carburetor bowl?

Locate the carburetor bowl. It’s a cylindrically shaped device with one or two bolts on the bottom (shown). If there are two bolts, the off-center one is a drain, which you can use to get rid of any fuel without removing the bowl; place a container beneath the carburetor and remove the bolt.

Why does my Harley idle so high?

If the idle is too high, the main problems are these: – Idle stop screw or eletronic idle level setting not adjusted correctly (probably not a big surprise….) – Throttle cable jammed so the throttle valves can not close. – Cable to cold start lever jammed so the throttle valves can not close.

What should a Harley idle at?

According to Harley-Davidson, carbureted models should be started on the enricher and allowed to idle for maybe 30 seconds; after that you can push the enricher back in as soon as the engine runs smoothly, and, of course, ride away.

What is the most reliable Harley Davidson engine?

’94-’03 Evo Sportsters, the most reliable bike H-D has ever made and probably ever will make. Evo Big Twin is a close second, but the unit construction of the Sportster avoids so many potential issues you face with a bike with separate engine, trans.

How long should you let a Harley warm up?

About one minute

Is it bad to let a motorcycle idle?

You’re better off just letting your motorcycle sit unless you are actually going to ride it for a fair distance. You see, idling your motorcycle in the cold not only wastes fuel, but it’s also stripping oil from critical components that help your engine run, namely the cylinders and pistons.

Do Harleys break down alot?

Harleys break down for several reasons. There is also the failure of Harley owners to maintain their bikes properly. Many owners consider maintenance too costly, and so skip regular servicing. The bikes will break down eventually, after a long period without maintenance.

Is 35000 miles a lot on a motorcycle?

Motorcycles with more than 40,000 miles are considered to be high-mileage bikes, but if it has been well maintained, the mileage could still make it a good purchase. Sports motorcycles are typically driven more aggressively and experience more engine wear.

What is done on a 10000 mile Harley service?

At the 10,000-mile service interval, the following services will be completed: Check front brake lever pin. Check brake caliper pins. Check brake caliper boots and bushings.

Why do Harley engines shake?

Do Harleys vibrate a lot? Harley-Davidson motorcycles, especially older models, vibrate because of their engine design. Pistons in Big Twin engines share a single crankpin, so they move simultaneously. The enormous weight is thrown around as these pistons move back-and-forth causes the vibration of the motorcycle.

Which Harleys are prone to death wobble?

Some say it only happens on Harleys (mostly on the Road King, Ultra Classic, the Electra Glide and FLH series), but actually the wobble can happen on any bike and can happen with either the front or the rear of the bike.

How much does it cost to rebuild a Harley Evo engine?

The price of the LongBlock assembly depends on engine specification, but starts at just $3,495 and includes shipping. Dealer labor to remove, complete the assembly and install the engine is priced separately. Some components such as cam choice and accessories selected to finish the engine are also separate.

Does BMW own Harley Davidson?

(MUNICH, GERMANY) Norbert Reithofer, CEO of Bayerische Motoren Werke AG, announced today that Harley-Davidson Motor Company has accepted a friendly merger agreement by BMW and will combine their motorcycle manufacturing facilities. Mr.

About the Author

You may also like these