Why is my Jandy heater not working?
Breaker or fuse may be tripped. Reset breaker or check fuse. If heat pump still does not run, call for service. Three-phase models only – The phases may be reversed or there may be a loss of phase, call for service.
How long should a Jandy pool heater last?
With proper installation and maintenance, a heat pump will generally have a lifespan of about ten years, though many have lasted longer. We at AquaCal have seen some last as long as 15 years! So those are some factors that will affect the lifespan of your heat pump.
How do you unlock a Jandy pool heater?
To unlock the Set Point Lockout, press and hold the UP and DOWN buttons for 7 – 10 seconds. The unit will display SET POINT UNLOCKED.
What does no flow mean on pool heater?
Usually, the pool heater says no flow. It means that there is debris or dirt that causes it to clog. Another reason is that the water level is low and blocks the basket due to dirt.
How many years does a pool heater last?
But fast heating for an average sized swimming pool means a whole lot of gas burning. Hence, why gas heaters are usually best for small spas. Not at all. The average lifespan for a pool heat pump ranges from 10-20 years.
Why is my Raypak pool heater not working?
If your Raypak heater doesn’t fire at all, first make sure the unit’s time clock is set to the “On” position. A simple lack of power sometimes leads to a non-firing heater, so check the fuse box for a tripped circuit breaker. Raising your pool’s water level may fix a Raypak heater that continuously turns on and off.
What is SPA mode on pool heater?
SPA: in this mode, the heater will automatically function to maintain the water temperature setting for SPA mode. POOL: in this mode, the heater will automatically function to maintain the water temperature setting for POOL mode. Use the MODE button to change modes.
What to do if your Jandy pool heat pump does not start?
The following provides symptoms and solutions for general troubleshooting problems for Jandy heat pumps. Heat pump will not start, no control board display. Breaker or fuse may be tripped. Reset breaker or check fuse. If heat pump still does not run, call for service.
How to troubleshoot a Jandy ae2000 heat pump?
Jandy Ae2000 Heat Pump Troubleshooting Diagnostic Condition Description LOW H2O FLOW Low or restricted water flow through the The external bypass valve is in the wron The LCD screen will display LOW H2O FLOW LOW COIL TEMPERATURE When the evaporator coil temperature is
What does the LCD display on a Jandy heat pump show?
The LCD display will display HIGH H2O on the top line and TEMPERATURE on the bottom line for the duration of the fault condition. This feature also remains active when the control calls for heat through a remote thermostat.
Is there a warranty on Jandy pool equipment?
Jandy pool equipment is sold exclusively through a nationwide network of qualified pool professionals with the expertise and ability to help pool owners make the best equipment decisions for their individual pool needs. Therefore, we do not provide a Manufacturer’s Warranty on Jandy equipment purchased online through any internet retailer.
